MASCO Catalog: Concrete Forming & Accessories

199 MASONS SUPPLY COMPANY Oregon (800) 537-3407 ♦ Washington (800) 537-6216 Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Ridgefield | Seattle | Tacoma | Woodinville M A S C O . N E T SWL information available on request. Inverted Wall Brace Insert For use in panels where the brace is to be attached to the "down face" or underside of the panel after it is lifted from the casting slab. These anchors are often referred to as "inverted" anchors. Uses standard coil threaded bolts. Supplied with plastic tipped feet and insert locator plugs installed. Approximate 2:1 safety factor rating in 2500 psi concrete. Recommended minimum distance from edge of panel or panel opening is 12". No. Size Wt (lbs) DS 5T5A ¾" 0.80 DS 512T5A DS 6T5A INVERTED WALL BRACING INSERT WALL BRACE TILT-UP/PRECAST TILT-UP Slant Connection Anchor The Slant Anchor assembly connects tilt-up or precast panels to the foundation. The assembly includes a load- rated Slant Anchor, foam Void Former, high-strength Ductile Bar and pre-packaged Grout. The Slant Anchor is integral to panel design and planning. The anchor is positioned and reinforced in each panel during concrete forming operations. The foam Void Former covers the connection sleeve during concrete placement. Once a completed tilt-up panel is ready for installation, the foam Void Former is removed. The opening for the connection sleeve is now visible and accessible for subsequent anchoring. Each panel is positioned on the foundation and braced. A hole is drilled into the foundation footing using the connection sleeve as a guide. This puts the load path near the center line of the panel. The hole is then partially grouted, the Ductile Bar inserted, and the remaining grout used to fill the sleeve. This grouted connection anchors the panel without welding or bolting. No. Type Panel Width Wt (lbs) SB TSAC Standard 7" min 10.0 SB PSAC Slim 5-1/2" - 7"