MASCO Catalog: Concrete Forming & Accessories

83 MASONS SUPPLY COMPANY Oregon (800) 537-3407 ♦ Washington (800) 537-6216 Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Ridgefield | Seattle | Tacoma | Woodinville M A S C O . N E T DYWIDAG THREAD TIEING/HANDSET SWL provides a factor of safety of approximately 2 to 1. B A D C Welded Angle Bracket Manufactured from high strength steel. Strengths are determined on full fillet welds along bracket. The threaded pin swivels up to ± 45°. The welded angle bracket is mainly used on H-piles below grade for one-sided forming applications. See technical bulletin for SWL reduction factor information. No. Size DSI 58AB 5/8" DSI 78AB 7/8" DYWIDAG Taper Tie Taper Ties employ one piece all steel tapering. This results in a stronger, much lighter system that uses the same size hardware at each end. No. Size Size Taper L Size Overall L Wt (lbs) SWL Tension (lbs) 7/8" DSI B20F28230 1-1/4" to 1" 30" 51" 12.0 32,500 DSI B20F28236 1-1/4" to 1" 36" 57" 13.5 32,500 5/8" SY 722125 3/4" to 5/8" 24" 49" 5.0 18,400 SY 722104 3/4" to 5/8" 16" 41" 4.0 18,400 Overall Length Taper Length Welded Neck Flange Offers an economical solution for one sided forming of steel where angle tying is not required. The strengths listed on the chart were determined based on a 1/4″ fillet weld completely around the base of the Neck Flange. No. Size DSI 5/8″ Rod Diameter A B C D SWL Tension (lbs) Wt (lbs) in. in. in. in. in. klps lbs. 5/8 1.18 5.12 0.47 1.96 21.9 4.0 D C A B