151 322
151
MASONS SUPPLY COMPANY
Oregon (800) 537-3407 ♦ Washington (800) 537-6216
Clackamas | Eugene | West Eugene | Hillsboro | Medford | Portland | Salem | Wilsonville | Ridgefield | Seattle | Tacoma | Woodinville
M A S C O . N E T
Power Sprayer
A full featured, easy-to-use power sprayer that can be positioned on top
of any container you wish to dispense from. The sprayer is designed to
replace the standard pump-up or gas-driven sprayers and will reduce
the time needed for most spray-on applications, freeing labor for other
tasks. The sprayer is available in either AC or DC power options that easily
spray high solids and high viscosity products. It reduces contamination
and spillage by dispensing products directly from their packaging. Simply
insert the suction line, connect the battery clips (DC) or plug it in (AC),
turn it on, and you are ready to spray. Shipped fully assembled. Durable
all steel construction. Easy to use with 100' of 3/8" chemical resistant hose
on a reel. Open flow quick connect fittings that allow for circulation,
purging excess contents out of unit and easy cleaning. Chemical resistant
diaphragm and seals in pump and reel. Circuit breaker that protects
the operator and eliminates searching for replacement fuses. Includes a
spray control gun, 1 straight and 1 curved 18" wand section, a 1 gal. per
minute fan tip and an adjustable cone nozzle. Will not separate water
based products as roller pumps can. Pressure sensitive switch stops pump
when you stop spraying. Sprays 3,600 ft² in about 5 min. at approximately
75 psi. Large rubber feet for stability.
No.
Description Wt (lbs)
PCS RP75AC AC (9' cord)
44.0
PCS RP75DC DC (25' cord) 44.0
FORM RELEASE
No.
Size
ACC 5GFS 5 gal. pail, 50 lbs., 24/pallet
Form Seal
Description
: Form seal is a pre-
catalyzed polyurethane coating
having outstanding abrasion, wear
and chemical resistance. The film has
a high degree of flexibility and works
extremely well pre-treating wood and
concrete formwork where medium
re-use of up to 40 casts are expected.
Form Seal can be used to seal all
types of wood or concrete formwork.
Application
: Remove any grease or
oils form the surface prior to use. Brush,
roll or spray a thin coat of Form-Seal. If
the surface to be coated is porous it is
best to apply a dilute solution of 2-parts
Form Seal and 1-part Xylene to assure
better penetration. Apply a second or
third coat to the surface while the first
coat remains tacky to assure proper
adhesion. If the first coat has dried prior
to the application of subsequent coats
lightly sand the surface to roughen it
and create a better anchor profile for
proper adhesion.
Note: When applying
Form- Seal to concrete mix it is best
to lightly sandblast or acid etch the
surface prior to applying the coating.
If acid etching is preferred, it is best
to wait a minimum of 48 hours before
proceeding with the Form Seal, allowing
for thorough drying of the concrete
substrate to be coated.
Specifications:
Specific Gravity:
0.985
Tensile Strength:
3,500 psi
Drying Time:
2-1/2 hours
Elongation:
150%
Impact Resistance:
160 in-lbs
Coverage
: 1 gallon yields 300-400 sq. ft.
per coat. 2 coats recommended.
FORM TREATMENT
SPRAYERS
FORM COATING
FORM TREATMENT